Top 7 Joist Hanger 2×4 – Hardware

As an Amazon Associate I earn from qualifying purchases.

1. USP Structural Connectors

#ad

USP Structural Connectors JL24 20 Gauge Face Mount Joist Hanger, 2 by 4, Pack of 50

#ad
USP Structural Connectors #ad - Made in the USA. Comparable to LU24. Not recommended for use with treated lumber. Light duty face mount hanger that connects a 2X4 joist to a wood header. G90 galvanized coating for corrosion resistance.
BrandUSP Structural Connectors #ad
ManufacturerUSP Structural Connectors #ad
Height3 Inches
Length3 Inches
Weight0.1 Pounds
Width4 Inches
Part NumberJL24
ModelJL24

2. RAW PRODUCTS CORP

#ad

316 Stainless Steel Joist Hangers JUS24 LUS24 Deck Framing 2 x 4 Single, Qty 10

#ad
RAW PRODUCTS CORP #ad - They are typically used to help form the floor on decking applications. In addition, only nails should be used when installing joist hangers. All decking joist hanger anchors in this selection are made of 316 Stainless Steel for superior corrosion resistance.

It is not recommended to mix metals during application. Joist hangers are available in single Sizes For singular, standard sized joists or Double sizes For thicker beams of timber or 2 joists side by side. Joist hangers wrap around three sides of a joist forming the parallel pattern often seen that make up deck floors, prior to being covered.

For example, a stainless steel joist hanger should be used with the same grade of stainless steel nails. Joist hangers are framing connectors attached to the ends of wood or timber joists to the ledger board. 316 stainless steel is well suited for applications in severe, harsh, or marine environments.
BrandRAW PRODUCTS CORP #ad
ManufacturerUSP #ad
Height1 Inches
Length1 Inches
Weight1 Pounds
Width1 Inches
Part Number6120-002-0006

3. South Gate/Almcan

#ad

Joist Hanger for 2" x 4" Nominal Lumber, 18G Steel G185 Triple Zinc Galvanized #450-3

#ad
South Gate/Almcan #ad - Easy to install. Perfect for contractors and DIY installations. Offer sturdy joist support. 18g steel g185 triple Zinc Galvanized. Dimensions: w 1-9/16", D 1-3/4". For actual dimensions, h 3-1/4", please refer to the image.
BrandSouth Gate/Almcan #ad
ManufacturerSouth Gate/Almcan #ad

4. Ozco

#ad

2 per Pack, OZCO 56641 Laredo Sunset 2x4 Top Rail Saddle

#ad
Ozco #ad - Corrosion resistant Coated; No Pre-Drilling Required. Hot dipped galvanized Steel; Powder Coated. Approved to use With ACQ Treated Lumber. Kit includes: 2 rail saddles; 12 #12 x 1-1/4-inch Torx HD T25. Hex head size 3/8-inch.
BrandOzco #ad
ManufacturerOZCO #ad
Height3.88 Inches
Length2 Inches
Weight1 Pounds
Width1.81 Inches
Part Number56641
Model56641

5. Eapele

#ad

Eapele 20pcs Deck Railing Brackets Connectors for 2x4 Railing Wood Post with 120pcs Wood Screws

#ad
Eapele #ad - Thickness up to 3cm, Eapele railing connectors create a strong and effective support to the deck rail. Package included-20pcs deck rail bracket connectors,120pcs black coating Iron screws.

When you use the square drive bit, please set your driver to the lowest torque. Makes for a super easy install of railings, even stair railings. Pre-drilled nylon material-made of high quality nylon that will never corrode or break. Eapele 90 degree railing connector makes attaching 2" x 4"true measurement of 1-3/8" x 3-3/8" or 2" X 6" true measurement of 1-1/2" x 5-3/8"railings to posts quick and easy. If you find that there are not enough parts,just contact us through amazon message system, we will send you the parts as oon as possible. Note-the material of these connectors are nylon, so take care in screwing them in. Do that, and you'll be fine.
BrandEapele #ad
ManufacturerEapele #ad
Height6 Inches
Length6 Inches
Width6 Inches

6. Simpson Strong-Tie

#ad

Simpson Strong Tie APHH46 Outdoor Accents 4-inch by 6-inch Concealed-Flange Heavy Joist Hanger, Steel, 3.75"

#ad
Simpson Strong-Tie #ad - Use the outdoor accents structural wood screw SDWS22312DBB and hex-head washer STN22 to connect to the joist. 12-gauge. Joist size: 4x6 or 4x8. Zmax powder coating. Use the strong-drive sds heavy-duty Connector screw SDS25300 to connect to the header.
BrandSimpson Strong-Tie #ad
ManufacturerSimpson Strong Tie #ad
Height0 Inches
Length3 Inches
Width0 Inches
Part NumberAPHH46
ModelAPHH46

7. USP

#ad

Mitek USP Structural-Connectors JL26 Face Mount Joist Hanger, G90 Galvanizing Finish Steel, Light-Capacity 20 Gauge, 2 x 6 Joist Dimensional Hangers, 50 Count

#ad
USP #ad - Lights duty. 20 gauge. Joist size : 2 x 6-8. Speed prongs designed to temporarily position hangers on headers for more convenient nail fastening. Face mount.
BrandUSP #ad
ManufacturerUSP #ad
Height1.5 Inches
Length8 Inches
Weight5.5 Pounds
Width2 Inches
Part NumberJL26
ModelJL26